LOCK-N-LOAD®OWNER'S MANUALRIFLEBULLETFEEDER
Item No.Production Part No. Qty. Description40 399327 1 Feeder Clamp, RBF41 69006 1 Thumb Screw, 6-32 X .4042 399322 1 Seat Adjust Screw, RBF43 399325
Die AdjustmentPreparationAs with all dies, disassemble the die and clean thoroughly.Reassemble according to the illustration. Do not attach the Feeder
Die PlacementWith a chamfered case in the shell plate, raise the press ram to the top of its stroke. Screw the assembled die into the press until resi
Set the bullet seat depth by lowering the press ram, threading the Seat Adjust Screw (42) into the die and raising the press ram again until the desir
Tune & Lock the DieNext, lower the press ram and remove the cartridge. Place the next set of components in the press and seat/crimp another round.
LoadPut a case in the shell holder and cycle the press ram. The bullet in the Alignment Sleeve (49) will seat into the case. Simultaneously the Feed B
Troubleshooting the Lock-N-Load®Rifle Bullet FeederProblems Possible Causes & SolutionsHopper does not turn on• Switch cable is not connected to t
APPENDIX B - TEMPLATE Lock-N-Load® AP™APPENDIX B
Item No.Production Part No. Qty. Description1 399213 1 Tube Spring Clamp2 399210 1 Button Head Cap Screw (BHCS) 10-32 X 1/43 392011 2 Hex Nut, 10-32,
68003004/2014P.O. Box 1848, Grand Island, Nebraska 68802-1848308-382-1390 • 800-338-3220 • Fax: 308-382-5761www.hornady.com • webmaster@hornady.
3738302536252526272834156791112131415161718192021323222429303014322810393533342031Lock-N-Load® Rifle Bullet FeederEXPLODED VIEW- 3 -
Hopper Installation and SetupSupport Tube InstallationPlace the Hornady® Lock-N-Load® AP™ template (located in the back of the manual) on the table i
Hopper InstallationSlide the hopper onto the Top Support Tube (29), with the hopper opening facing the front of the bench.Place a ¼-20 x 2 SHCS Bolt (
Item No.Production Part No. Qty. Description67 399345 1 Switch Retainer, 22 Cal68 399343 1 Feed Tube, 22 Cal69 399347 3 4-40 X 11/16 Pan Head ScrewIte
Hopper TestingPlug in the Power Supply (34) and turn on the empty feeder using the 2 Position Switch (32). If the feeder doesn’t turn on, refer to 12A
Short Feed BlockSlot in Feeder BlockTorsion SpringFeeder BlockShoulder BoltFeeder CapTall Feed BlockSwitch Adjustment (if necessary)12A: Hopper does
Lock RingFeeder ClampDie BodyFeeder BodyBullet RampFeeder Support BracketCompression Spring & Dowel PinPan Head ScrewThumb ScrewBullet Drop Adjus
Commentaires sur ces manuels