Hornady Lock-N-Load Case Feeder Manuel d'utilisateur télécharger pdf (Page 11)

Feed Tube End

Push Rod

Feed Tube

Select the proper Feed Tube and insert it in the top of the

Feed Tube End. If you select the Feed Tube End, you will have

to use the Plastic Feed Tube Small Bushing (66).

Refer to page 13.

(When feeding some cases, such as the 357 Mag, you may

notice that the base of the case will not fall into the hole

of the Pivot every time. The base will ride on the radius of

the pivot hole. This is correct because when the Push Rod

starts to rotate the Pivot, the case will fall into the hole.)

Feed Tube

Bushing

Small

Feed Tube

Placing the Feed Tube end on

the Assembly (con't).

ASSEMBLY

- 11 -

ASSEMBLY: CASE FEEDER

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Hornady Lock-N-Load Case Feeder Manuel d'utilisateur Page 11