Hornady Lock-N-Load Pistol Bullet Feeder Manuel d'utilisateur

LOCK-N-LOAD®OWNER'S MANUALBULLETFEEDER(PISTO L)

Insert the Drop Funnel (5) into Tube Spring Clamp (3). You will want the front edge (outside edge) of the Drop Funnel as close to the Bullet Feed Whee

Setup / Changeover of the Lock-N-Load® Pistol Bullet FeederThe Hornady Lock-N-Load® Pistol Bullet Feeder is capable of feeding most pistol bullets. Wh

Adjusting the Top WiperThe Top Wiper is intended to remove nose heavy bullets that do not fall off when pointed nose down on the Bullet Feed Plate . P

Bullet Feed Die Set UpDisassemble the die and lay the parts out on a flat surface.Degrease every part of the die.Reassemble the die as you took it apar

- 14 -

APPENDIX B - TEMPLATE Lock-N-Load® AP™- 15 -

399176 03/2014P.O. Box 1848, Grand Island, Nebraska 68802-1848 308-382-1390 • 800-338-3220 • Fax: 308-382-5761 www.hornady.com • webmaster@hor

Table of ContentsASSEMBLYPistol Bullet Feeder ... Page 3CHANGE-OVERSThe Hornady Lock-N-Load® Pi

Lock-N-Load® AP™ Pistol Bullet FeederOVERVIEWYour new Lock-N-Load® AP™ Pistol Bullet Feeder has been packaged to ensure minimal vibration and damage d

Item No.Production Part No. Qty. Description1 392011 3 Nut Hex 10-32 Zinc2 399209 1 Steel Knurled Thumb Screw3 399213 1 Tube Spring Clamp4 399210 1 BH

Lock-N-Load® AP™ Pistol Bullet FeederEXPLODED VIEWASSEMBLY- 5 -ASSEMBLY: PISTOL BULLET FEEDER

Mounting the Bullet Feeder to the Bench Refer to Appendix B for the template.Place the template on the table in the location you would like to mount

Place a ¼-20 X 2 SHCS Bolt (30) with one ¼" Flat Washer (31) through the bottom hole of the Bullet Feed Hopper and the Square Tubing Mounting Bra

Place a ¼" Flat Washer (31) over the end of each of the two Bolts just previously place through the Bullet Feed Hopper and Square Tubing Mounting

Install the wipers as with one Wing Nut (25) installed on the outside of the Bullet Feed Hopper on the Wiper Screw (24).Loosen the wing nuts.Place two